Es gibt Lautsprecher und dann gibt es noch die LS3/5A. Sie spaltet sowohl ihre Hörer, als auch die, die sie gar nicht kennen. Warum das so ist? Nun, dafür muss man sich vor allem anschauen und natürlich hören, was sie kann und nicht, was sie nicht kann.
>> Mehr erfahren>> Alle anzeigenMit diesen Chassis wollte ich schon immer mal etwas bauen. Dass ich sie allerdings jemals zusammen in einer Box haben würde, hätte ich dann doch wieder nicht erwartet – dass das Ganze so gut werden würde, dann schon eher.
>> Mehr erfahren>> Alle anzeigenKategorie: Verstärker Röhrenverstärker
Ausstattungsliste: Audio Research Reference 160 S
TECHNICAL SPECIFICATION | |
POWER OUTPUT | 140 watts continuous from 20Hz to 20kHz. 1kHz total harmonic distortion typically 1% at 140 watts, below 0.04% at 1 watt. |
(Note that actual power output is dependent upon both line voltage and “condition” i.e.: if power line has high distortion, maximum power will be affected adversely, although from a listening standpoint this is not critical). | |
POWER BANDWIDTH | (-3dB Points) 5Hz to 70kHz. |
FREQUENCY RESPONSE | (-3dB points at 1 watt) 0.5Hz to 110kHz. |
INPUT SENSITIVITY | 2.4V RMS Balanced for rated output. (25.5 dB gain into 8 ohms). |
INPUT IMPEDANCE | 300k ohms Balanced; 100k ohms Single-ended. |
OUTPUT POLARITY | Non-inverting. Balanced input pin 2+ (IEC-268). |
OUTPUT TAPS | 16 ohms, 8 ohms, 4 ohms. |
OUTPUT REGULATION | Approximately 0.6dB 16 OHM LOAD TO OPEN CIRCUIT (Damping factor approximately 14). |
OVERALL NEGATIVE FEEDBACK | 14dB SLEW RATE: 13 volts/microsecond RISE TIME: 2.0 microseconds. |
POWER REQUIREMENTS | 105-130VAC 60Hz (210-250VAC 50Hz) 400 watts at rated output, 700 watts maximum, 260 watts at “idle”, 1 watt off. |
TUBES REQUIRED | 4 matched pair KT150 (Power output V1-4); 4 6H30 (Gain stage V5 and V6). |
DIMENSIONS | Width 19.0” (48.26 cm) Height 10.25” (26 cm) Depth 21.5” (54,61 cm) With Handles and Connectors: 24” (60.96 cm) |
WEIGHT | 100lbs |
141-589
Sound @ Home |