Mit diesen Chassis wollte ich schon immer mal etwas bauen. Dass ich sie allerdings jemals zusammen in einer Box haben würde, hätte ich dann doch wieder nicht erwartet – dass das Ganze so gut werden würde, dann schon eher.
>> Mehr erfahren>> Alle anzeigenVon Audio System gibt es eine Vielzahl an Nachrüstlautsprechern für Audi. Wir schaffen den Überblick und testen das RFIT Set für den A6 C8.
>> Mehr erfahren>> Alle anzeigenKategorie: Verstärker Röhrenverstärker
Ausstattungsliste: Audio Research Reference 160 M
TECHNICAL SPECIFICATION | |
POWER OUTPUT | 140 watts continuous from 20Hz to 20kHz. 1kHz total harmonic distortion typically 1% at 140 watts, below 0.04% at 1 watt. |
(Note that actual power output is dependent upon both line voltage and “condition” i.e.: if power line has high distortion, maximum power will be affected adversely, although from a listening standpoint this is not critical). | |
POWER BANDWIDTH | (-3dB Points) 5Hz to 70kHz. |
FREQUENCY RESPONSE | (-3dB points at 1 watt) 0.5Hz to 110kHz. |
INPUT SENSITIVITY | 2.4V RMS Balanced for rated output. (25.5 dB gain into 8 ohms). |
INPUT IMPEDANCE | 200 k ohms Balanced. |
OUTPUT POLARITY | Non-inverting. Balanced input pin 2+ (IEC-268). |
OUTPUT TAPS | 16 ohms, 8 ohms, 4 ohms. |
OUTPUT REGULATION | Approximately 0.6dB 16 OHM LOAD TO OPEN CIRCUIT (Damping factor approximately 14). |
OVERALL NEGATIVE FEEDBACK | 14dB SLEW RATE: 13 volts/microsecond RISE TIME: 2.0 microseconds. |
POWER REQUIREMENTS | 105-130VAC 60Hz (210-250VAC 50Hz) 400 watts at rated output, 700 watts maximum, 260 watts at “idle”, 1 watt off. |
TUBES REQUIRED | 2 matched pair KT150 (Power output V1-4); 2 6H30 (Gain stage V5 and V6). |
DIMENSIONS | Width 17.25” (43.8 cm) Height 10” (25.4 cm) Depth 18.5” (47 cm) Handles Extended 19.25” (48.9 cm) |
WEIGHT | 56lbs (25.5 kg) Net |
141-589
Sound @ Home |